Sirius Satellite Radio Sportster 6 User Manual page 29

1. Feed Cable Under
Rubber Seal Around
Hatch Opening
Follow these detailed cable installation instructions:
1. Feed the antenna cable underneath the rubber weather stripping of the rear tail-
gate window/door and route the cable along the rear hatch. Lift the weather strip-
ping from the opening and tuck the cable inside it, then replace the weather strip-
ping. Pull the cable out from weather stripping and route it into the cabin under the
interior trim. Avoid hinges or gears that could crimp or cut the cable.
2. Route the cable through the SUV's main cabin area under the interior trim, towards
the front of the vehicle. Use a plastic putty knife to lift the plastic trim just enough
to tuck the cable under underneath. Avoid side airbag locations on back pillars and
above the doors. (Airbag locations are marked with "SRS" logos.) Be careful not
to crimp or cut the cable.
A
NTENNA
figure 13
4. Bring Cable Out To
SIRIUS Receiver
Location
3. Route Cable
2. Route Cable Under Interior
Trim, into Cabin and
Towards Front of Vehicle
[
Under Carpet
to Dashboard
]
29
Installation