Component Identification; Operation; Pressure Relief Procedure - Graco EDGE 257827 Important Safety Instructions Manual

Component Identification

D
E
C
B
A
ID Component
A Siphon Cup
B Check Valve
C Air Cap
D Air Nozzle
E Fluid Needle
G Trigger Slide

Pressure Relief Procedure

The spray gun cup is pressurized by the gun air supply.
To reduce the risk of serious injury from pressurized fluid
or accidental spray from gun, always turn off the air sup-
ply to the gun before removing the spray gun cup. Unplug
sprayer from outlet
Setup
Make sure sprayer is turned off and unplugged from
power source. Refer to your sprayer instruction manual
for spray setup.
Connect Gun to Siphon Cup
1. Attach air hose from sprayer to
inlet fitting of gun.
2
G
J
H
K
M
ti13820a
N
ID Component
H Air Inlet
J ™
EasyGlide Trigger
K Latch
M Swivel Tube
N Strainer
ti12797a
2. Fill cup 3/4 full. Install cover. Latch
the gun cup cover to secure it to
siphon cup.

Operation

Adjust Spray Pattern
1. Set air cap to position for spray pattern desired.
2. Verify trigger slide is in SPRAY position (E) and not
NEEDLE REMOVAL position (D).
D
Optional Trigger Stop Adjustment (257086)
Flow and pattern size is determined by the trigger stop.
Set knob to OFF. Increase flow to attain desired spray
pattern.
ti13832a
Spray
1. Keep gun perpendicular to surface and at a distance
of 6 to 8 in. (150 to 200 mm) from surface.
Component Identification
ti12872a
ti12763a
E
ti12795a
ti12823a
313754C