Operation - Jet JML-1014VS Owner's Manual

Receiving
1. Remove contents from the shipping box.
2. Inspect contents for shipping damage and report
damage, if any, to your distributor.
3. Be sure to keep the box and packing material
should you need to pack the lathe for moving.
4. Exposed metal surfaces on the lathe have been
factory-treated with a protectant, and should be
cleaned with a soft rag. Do not clean the lathe
with anything other than a damp cloth or a mild
solvent. Use of heavy solvents, paint thinner,
gasoline, etc. will damage painted surfaces.
Contents of the Shipping Carton:
1 - Lathe w/ motor and tailstock
1 - Tool rest
1 - Face plate
1 - Knockout rod
1 - Live center
1 - Spur center
1 - Safety goggles
1 - Owner's manual
1 - Warranty card
Assembly
The JML-1014 is fully assembled and comes ready
to use right out of the box. However, it is a good
practice to thoroughly check the machine for loose
fasteners, handles, etc. before use.
If desired, the lathe can be bolted to a work table or
stand by removing the rubber feet and inserting
screws through the holes in the base. A stand
specifically made for this lathe is available (stock
#708354).

Operation

Tailstock Handwheel (A, Fig. 2) - Turn clockwise
to move tailstock spindle forward. Turn counter-
clockwise to retract tailstock spindle.
Tailstock Spindle Lock (B, Fig. 2) - Locks tailstock
spindle. Release to adjust with handwheel.
Tailstock Lock (C, Fig. 2) - Locks tailstock in
position on the bed. Release to move tailstock
assembly closer to or farther from the headstock.
7