Belt Replacement - Jet JML-1014VS Owner's Manual

3. Loosen the motor plate lock handle (A, Fig. 12).
Lift up on the motor plate handle (B, Fig. 12) to
take tension off the belt.
4. Move the belt (B, Fig. 10) to the desired pulley
groove according to the speed chart found on
the inside of the headstock access door. Be
sure the belt is aligned with spindle pulley and
motor pulley.
5. Tension the belt by pushing down on the motor
plate handle (B, Fig. 12) and lock in place.

Belt Replacement

1. Disconnect the machine from the power source
(unplug).
6. Open the access doors at the left side of the
base (Fig. 10), and at the back side of the
headstock (Fig. 11).
2. Loosen the motor plate lock handle (A, Fig. 12).
Lift up on the motor plate handle (B, Fig. 12) to
take tension off the belt.
3. Loosen the set screw (B, Fig. 11) on spindle
pulley (upper).
4. Loosen two set screws in handwheel (C, Fig.
11). Unscrew the handwheel while holding onto
the spindle.
5. Remove handwheel and pull the spindle out
while holding onto the spindle pulley.
6. Place the new belt on the spindle pulley. Place
the spindle pulley back into the headstock the
same way it was removed.
7. Insert the spindle into the spindle pulley aligning
the key.
8. Thread the handwheel onto the spindle leaving
a little space between the handwheel and
headstock. Tighten set screws.
9. Center the spindle pulley and tighten set screw.
10. Wrap the belt around the motor pulley (lower).
Be sure the belt is aligned with spindle pulley
and motor pulley.
11. Tension the belt and tighten the motor plate lock
handle.
11