Setting The Fax For Network Switch; Network Switch System Operation - Canon FAX-L290 User Manual

Setting the FAX for Network Switch

Follow this procedure to set the receive mode to NET SWITCH:
1
Open the one-touch speed dial panel.
2
Press Data Registration.
3
Press Set.
Use ∂ or ¨ to select RX SETTINGS.
4
5
Press Set.
Use ∂ or ¨ to select RX MODE.
6
7
Press Set.
Use ∂ or ¨ to select NET SWITCH.
8
9
Press Set.
10
Press Stop to return to standby mode.
n
When the RX MODE setting is set to NET SWITCH, no other receive mode can be
selected with the Receive Mode button.

Network Switch System Operation

The procedure for using the network switch system is almost the same as when using
the FAX over a normal telephone line. When you receive calls, however, the unit will
respond slightly differently as described below:
When you hear the telephone call ring pattern:
Pick up the handset and talk normally. If you hear a slow beep, it means the call is from
a fax machine trying to send a fax. Press Start/Copy to receive the fax. If you do not
pick up the handset, the unit continues to ring until the other party hangs up. If an
answering machine is connected, it takes over the call.
When you hear the fax call ring pattern (triple ring):
After the unit rings, it receives the document automatically.
C-6
Country-specific Features
DATA REGSTRATION
USER SETTINGS
RX SETTINGS
ECM RX
RX MODE
Ex:
FAX ONLY MODE
NET SWITCH
INCOMING RING
Ex:
15:00 NET SW.
Appendix C