Canceling Receiving; Setting The Fax For Network Switch; Operation For Network Switch System - Canon FAX-JX300 User Manual

Canceling Receiving

1
Press [Stop].
Telstra FaxStream™ Duet (Australia only)
Telstra offers the FaxStream™ Duet capability. If you subscribe to this service, your line is assigned
two numbers: one for fax and one for phone. When the fax number is called, the network sends a
specific ringing tone which your fax recognizes and automatically handles as a fax call. If the phone
number is called, a different ringing tone is sent out from the network so that the call is handled as a
voice call. This means that there is no switching delay at the other party's end.
Contact Telstra for connection information.

Setting the Fax for Network Switch

When the fax number is called, you will hear a triple-ring* ringing tone.
When the telephone number is called, you will hear a ringing tone other than the triple-ring
ringing tone. The ringing tone depends on your switchboard.
1
Press [Receive Mode/Resolution] to select <NET SWITCH>.
See "Setting the Receive Mode" on page 28.
}
The fax returns to standby mode.
* Three short rings (short-short-short) at regular intervals.

Operation for Network Switch System

The procedures for using the network switch system are almost the same as when using the fax
over a normal telephone line. When you receive calls, however, the fax will respond slightly
differently as described below.
When you hear the telephone call ring pattern:
Pick up the Handset and talk normally. If you hear a slow beep, it means the call is from a fax
machine trying to send a document. Press [Start/Copy] to receive the document. If you do not
pick up the Handset, the fax continues to ring until the other party hangs up. If an answering
machine is connected**, it takes over the call.
** FAX-JX500/JX300 only.
When you hear the fax call ring pattern (triple ring):
After the fax rings, it receives the document automatically.
30 Receiving Faxes