Table of Contents
Advertisement
09 Maintenance and service
Battery
09
NOTE
Tighten the screws to 30 Nm. Check the
torque with a torque wrench.
Fitting
1. Lower the battery into the battery box.
2. Move the battery inward and to the side
until it reaches the rear edge of the box.
3. Tighten the clamp that holds the battery.
4. Connect the ventilation hose.
> Check that it is correctly connected to
both battery and outlet in the body.
5. Connect the red positive cable.
6. Connect the black negative cable.
7. Press in the rear cover. (See Removal.)
Absorbed Glass Mat
1
368
8. Fit the rubber moulding. (See Removal.)
9. Align the front cover and secure it with
the clips. (See removal.)
For more information on the car's starter bat-
tery - see page 409.
Start/Stop
Cars with the Start/Stop function are equip-
ped with two 12 V batteries - one extra pow-
erful battery for starting and one support bat-
tery that helps during the Start/Stop func-
tion's starting sequence.
For more information on Start/Stop - see
page 132.
For more information on the car's starter bat-
tery - see page 122 and 409.
Battery
Start
Cold start
capacity
A
,
760
CCA (A)
B
Size
,
278×175×190
L×W×H
(mm)
Capacity
70
(Ah)
In accordance with the SAE standard.
A
B
Largest possible size.
IMPORTANT
When replacing batteries in cars with the
Start/Stop function, the AGM
1
ies must be fitted.
Support
180
150×90×130
10
type batter-
Advertisement
Table of Contents
