Table of Contents
Advertisement
Pull out the headlamp's locking pins.
Release the headlamp by alternately tilt-
ing and pulling it out.
IMPORTANT
Do not pull the electrical cable, only the
connector.
Detach the headlamp connector by
pressing down the clip with your thumb.
At the same time, guide out the connec-
tor with your other hand.
5. Lift out the headlamp and place it on a
soft surface to avoid scratching the lens.
6. Replace the bulb in question.
Securing the headlamp
1. Plug in the connector, a clicking sound
should be heard.
2. Reinstall the headlamp and locking pins.
The short pin is fitted closest to the grille.
Check that they are correctly inserted.
3. Check the lighting.
The headlamp must be mounted and the con-
nector correctly installed before the lighting is
switched on or the remote control key is
inserted into the ignition switch.
09 Maintenance and service
Removing the cover
Before starting to replace a bulb, see
page 356.
1. Unscrew the cover's four screws using a
Torx tool, size T20 (1). They should not be
loosened completely. (3 - 4 turns are suf-
ficient.)
2. Slide the cover to one side.
3. Remove the cover.
Reinstall the cover in reverse order.
Lamps
09
357
Advertisement
Table of Contents
