Dmx Control With Id Addressing; Static Color; Auto Programs; Edit Customs - Chauvet COLORado 2 Tour User Manual

Operation
DMX Control With ID
Addressing

Static Color

Auto Programs

Edit Customs

-10-
Continued from previous page
In this mode, the fixtures with the same DMX starting address will respond to the DMX
controller based on the fixture's individual ID address setting. If the user selects ID
address "0", all the fixtures with the same DMX address will respond in unison.
Otherwise, each fixture will follow the control for its particular ID address.
1) Repeat steps 1, 2, and 3 from DMX Control Without ID Addressing.
2) Activate ID Addressing in each fixture:
a) Press <MENU> repeatedly until SET shows; press <ENTER> to accept.
b) Use <UP> or <DOWN> to select ID and press <ENTER> to accept.
c) Use <UP> or <DOWN> to select ON and press <ENTER> to accept.
d) Press <MENU> twice to return to the main level.
The Static Color mode allows for permanent RGBW color mixing without a DMX
controller.
1) Press <MENU> repeatedly until STAT shows; press <ENTER> to accept.
2) Use <UP> or <DOWN> to select the desired color (Red, Green, Blue, or White).
3) Press <ENTER> to accept.
4) Use <UP> or <DOWN> to select the desired color value (0~255).
5) Press <ENTER> to accept.
6) Repeat for the other colors.
7) Use <UP> or <DOWN> to select Strob; press <ENTER> to accept.
8) Use <UP> or <DOWN> to select the desired frequency (0~20).
9) Press <MENU> twice to return to the main level.
Auto programs allow for dynamic RGBW color mixing without a DMX controller. This
product has two types of Auto programs, preset (AT. 01~10) and custom (PR. 01~10).
1) Press <MENU> repeatedly until AUTO shows; press <ENTER> to accept.
2) Use <UP> or <DOWN> to select the desired auto program (AT. 01~10 or PR.
01~10).
3) Press <ENTER> to accept.
You cannot edit preset Auto programs AT. 01~10. However, you can edit the
custom Auto programs PR. 01~10 (see Edit Customs).
This setting allows the programming of up to 30 scenes for each of the 10 customizable
programs, including colors and effects.
1) Press <MENU> repeatedly until EDIT shows; press <ENTER> to accept.
2) Use <UP> or <DOWN> to select the desired auto program (PR. 01~10).
3) Press <ENTER> to accept.
4) Use <UP> or <DOWN> to select the desired scene (SC. 01~30).
5) Press <ENTER> to accept.
6) Use <UP> or <DOWN> to select the desired color or effect (Red, Green, Blue,
White, Strobe, Time, or Fade).
7) Press <ENTER> to accept.
8) Repeat for the other colors or effects.
9) Press <MENU> to return to the Scene level.
10) Repeat for the other scenes.
11) Press <MENU> to return to the main level once done.
Continues on the next page
COLORado™ 2 Tour User Manual Rev. 02b