ATEN Slideaway CL1008 User Manual page 15

No. Component
1 Handle
2 Slide Release
3 LCD Display
4 LCD Controls
5 Port Switches
6 Port LEDs
7 Keyboard
8 Touchpad
9 Power LED
10 Rack Mounting
Brackets
11 Lock LEDs
12 Reset Switch
13 Firmware
Upgrade
Section
Pull to slide the KVM module out; push to slide the module in
(see item 2 in this table).
In order to slide the console out, you must first release it by
sliding these tabs to the inside. See page 13 for details on
sliding the console in and out.
After sliding the KVM module out, flip up the cover to access
the LCD monitor.
The LCD On/Off switch is located here, as well as buttons to
control the position and picture settings of the LCD display.
See page 17 for details.
Press a switch to bring the KVM focus to the computer
attached to its corresponding port. See page 19 for details.
Two Port LEDs are built into the Port Switches. The one on
the left is the On Line LED; the one on the right is the
Selected Port LED:
An On Line LED lights ORANGE to indicate that the
computer attached to its corresponding port is up and
running.
A Selected LED lights GREEN to indicate that the
computer attached to its corresponding port has the KVM
focus. The LED is steady under normal conditions, but
flashes when its port is accessed under Auto Scan Mode
(see F7: SCAN, page 33).
Lights DARK GREEN to indicate that the unit is receiving
power.
The rack mounting brackets located at each corner of the unit
secure the chassis to a system rack.
The Num Lock, Caps Lock, Scroll Lock LEDs are located
here.
Located to the right of the Lock LEDs. Press this recessed
switch in with a small object to perform a system reset.
Firmware Upgrade Port: The Firmware Upgrade Cable
that transfers the firmware upgrade data from the
administrator's computer to the CL1008 / CL1016 plugs
into this RJ-11 connector.
Firmware Upgrade Switch: During normal operation this
switch should be in the NORMAL position. (See page 41
for firmware upgrading details.)
Chapter 1. Introduction
Description
5