Peripheral Configuration - NEC N8100-1575F User Manual

4-14 Configuring Your Server

Peripheral Configuration

IMPORTANT:
overlapped with others. If the value set for the interrupt or base I/O
address is used in another resource, the yellow asterisk (*) appears.
Reset any item with the yellow asterisk properly.
Option
Serial Port A
Base I/O
address
Interrupt
Serial Port B
Base I/O
address
Interrupt
USB 2.0 Controller
Serial ATA
SATA AHCI
SATA RAID
IMPORTANT: To use the remote media feature of EXPRESSSCOPE
Engine 2, select "Enabled" for [USB 2.0 Controller].
Note that the interrupt and/or base I/O address are not
Parameter Description
Disabled Selects whether serial port A is enabled or
[Enabled] disabled.
[3F8h] Selects the base I/O address for serial port
2F8h A.
3E8h
2E8h
IRQ 3 Selects the interrupt for a serial port A.
[IRQ 4]
Disabled Selects whether serial port B is enabled or
[Enabled] disabled.
3F8h Selects the base I/O address for serial port
[2F8h] B.
3E8h
2E8h
[IRQ 3] Selects the interrupt for a serial port B.
IRQ 4
Disabled Selects the USB 2.0 controller is enabled or
[Enabled] disabled.
Disabled Selects whether the serial ATA is enabled or
[Enabled] disabled.
[Disabled] Displays whether AHCI (Advanced Host
Enabled Controller Interface) is enabled or disabled.
(View only)
This option is enabled when SATA RAID is
enabled.
[Disabled] Displays the RAID configuration jumper
Enabled switch is set to [RAID enable] position or
not. (View only) See Chapter 4 for details.
Your Setting
[ ]: Factory-set