Dimm - NEC N8100-1575F User Manual

11-12 Upgrading Your Server

DIMM

Install the additional DIMM (Dual Inline Memory Module) to the DIMM sockets on the mother
board. The mother board is provided with 8 DIMM board slots.
IMPORTANT:
The DIMM is extremely sensitive to static electricity. Make sure to
touch the metal frame of the server to discharge static electricity
from your body before handling the DIMM. Do not touch the
DIMM terminals or on-board parts by a bare hand or place the
DIMM directly on the desk. For static notes, see the section "Anti-
static Measures" described earlier.
Make sure to use the DIMM authorized by NEC. Installing a third-
party DIMM may cause a failure of the DIMM as well as the server.
Repair of the server due to failures or damage resulted from
installing such a board will be charged.
Purchase DIMMs of the following models:
– N8102-339 Additional 1-GB memory board
– N8102-340 Additional 2-GB memory board
– N8102-341 Additional 4-GB memory board
NOTE: Up to 32GB of memory (4GB DIMM × 8) can be installed.
(The factory-installed DIMMs need to be replaced in this case.)
CPU1_DIIMM #2
CPU1_DIIMM #4
CPU1_DIIMM #1
CPU1_DIIMM #3
REAR
Mother board
CPU1_DIIMM #3
CPU1_DIIMM #1
CPU1_DIIMM #4
CPU1_DIIMM #2
FRONT