Xytronix Research & Design WebSwitch XRDI-WS3 User Manual page 94

Revision 1.1
System log file: syslog.txt
***The setup user name and password are required to access this file.
This log file records various system events which can be used for diagnostics and troubleshooting
purposes. This file can be up to 16K bytes long.
File Format:
MM/DD/YYYY HH:MM:SS, (category to which message applies): (message)
Examples:
01/02/2010 04:08:13 DEVICE: Power Up.
01/01/2010 00:41:05 DEVICE: Reset factory defaults.
Listed below is a description of messages that a user may see:
Category:
DEVICE
EMAIL
CLOCK
NTP SERVER
REMOTE
SERVER
DHCP
MAIN_MCU
Xytronix Research & Design, Inc.
Message: Description:
Power Up Device has been properly powered.
Initialize Device is ready.
Reset Factory Device has been reset to factory defaults.
Defaults
Failed DNS Unable to lookup mail server due to an incorrect DNS setting.
Lookup
Bad Username Email was not sent due to an incorrect user name.
Bad Password Email was not sent due to an incorrect password.
Authentication A user name and password are required by the mail server.
Required
No Response No response from SMTP server.
RTC Reset Real Time Clock has been reset.
Request Attempt Device attempting to connect to NTP Server
Failed DNS Unable to lookup NTP server name due to an incorrect DNS setting.
Lookup
Success Device successfully connected to NTP Server.
Failed DNS Unable to lookup Remote Server due to an incorrect DNS setting.
Lookup
Connection Connection port with Remote Server has ben opened.
Attempt Started
Connection Connection port with the Remote Server has been closed.
Closed
Address Acquired IP address request successful, and IP address assigned.
Lease Renewal IP address assigned to device was renewed.
New Firmware New firmware has been loaded to the device.
Loaded
WebSwitch™ Users Manual
93