Xytronix Research & Design WebSwitch XRDI-WS3 User Manual page 86

Revision 1.1
downloaded from the ControlByWeb™ web site.
Step 7: Carefully follow these steps:
(a) Remove power to WebSwitch™.
(b) Press and hold the reset button as described in Appendix A.
(c) While holding the reset button, apply power to WebSwitch™. The Link and Act
lights will flash. Continue to hold the reset button without releasing for the next step.
(d) While holding the reset button, press the Upload Firmware button at the bottom of the
ControlByWeb™ Programmer window.
(e) After the programming process begins, the reset button can be released.
Step 8: Wait for Link LED to turn on such that it is continuously on. This may take up to 10-20 seconds.
Programming should be complete. WebSwitch™ will be set to factory defaults with an IP address of
192.168.1.2. Verify the new version of firmware has been installed by viewing the default setup page
with a web browser (http://192.168.1.2/setup.html).
Xytronix Research & Design, Inc.
WebSwitch™ Users Manual
85