Xytronix Research & Design WebSwitch XRDI-WS3 User Manual page 52

Revision 1.1
Off Status Text
The text in this field specifies the text that will be displayed in the control page and in email
messages when the input is OFF (input is open). Up to 15 characters may be entered in this field.
The default text is OFF.
Email Option
Simple email messages can be sent in response to input changes. This parameter is used to specify
what input changes, if any, will cause email messages to be sent. Note that email notification will
work only if the email settings are correctly set up in the Network setup page. The following options
are available:
-No Email Messages: No email notifications will be sent due to input changes.
-Send Email when input on: Email notifications will be sent when input state changes to on.
-Send Email when input off: Email notifications will be sent when input state changes to off.
-Send Email when input changes state: Email notifications will be sent when input changes
state to on or off.
Note: The default setting for this field is No Email Messages.
Use Email Address
If email messages are to be sent out based on input changes, these check boxes specify to which
email addresses the message will be sent. Email addresses specified on the Network setup tab will
be displayed next to each check box. By default, no boxes are checked.
Remote Service/SNMP
When this box (Send State Msg/Trap on Input Change) is checked, SNMP traps and/or State
messages will be sent whenever the input state changes.
Xytronix Research & Design, Inc.
WebSwitch™ Users Manual
51