Department Options - Uniden BCD436HP Owner's Manual

department optIons

edit name
edit Channel
Edit Name
See Data Naming.
Edit Channel
See Channel Options.
Set Location Information
Location Control enabled or with a GPS. You can program a circle with a radial range or multiple
rectangles as a location.
See Set Up GPS first.
Circle
Set Latitude
Enter the latitude. Press ./no to toggle N or S, and press E/yes.
Set Longitude
Enter the longitude. Press ./no to toggle E or W, and press E/yes.
Set Range See also Understanding Range.
0-6000
Rectangles
New Rectangle
Latitude - Top Left
Enter the latitude. Press ./no to toggle N or S, and press E/yes.
Longitude - Top Left
Enter the longitude. Press ./no to toggle E or W, and press E/yes.
Latitude - Bottom Right
Enter the latitude. Press ./no to toggle N or S, and press E/yes.
Longitude - Bottom Right
Enter the longitude. Press ./no to toggle E or W, and press E/yes.
Stored Rectangle
Edit Rectangle See Rectangles above.
Delete Rectangle
At Confirm Delete? press E/yes or ./no.
Set Avoid – This determines whether a Department will be scanned or not. Temporary Avoids
cancel when you cycle power.
The default setting is Stop Avoiding.
Stop Avoiding, Temporary Avoid, or Permanent Avoid
See also Scan Avoids.
Delete Department – Deletes the Department.
At Confirm Delete? press E/yes or ./no.
New Department – See New Department.
set location Information
set avoid
– This allows you program a location for the Department to use with
delete department
new department
45