Table of Contents
Advertisement
Special functions
Software Update
Favorites
Nein
Delete lists
Channel list
Formate Hard Disk
Cancel
Factory Reset
Remote Control
Receiver 1
Select
Back
and open
Installation
Menu language
Channel search
Video output
Time
Special functions
Info
Select
Back
and open
Channel search
Australia
Raster/Country
Off
Antenna supply
Automatic search
Manual search
Select
Back
and open
ADDITIONAL FUNCTIONS
Deleting channels or favourite lists
You can delete channels from the channel list and favourites list.
In the »Main Menu«, select »Installation« with »P-« or »P+«
1
and press »OK« to confirm.
2
Select »Special functions« with »P-« or »P+« and press »OK«
to confirm.
Select »Delete lists« with »P-« or »P+« and press »OK« to
3
confirm.
4
Select the list to be deleted with »P-« or »P+« and press »OK«
to confirm.
– The message »Execute?« appears.
5
Press » « or » « to select »Yes« or »No«.
– If »Yes« is selected for the channel list, the channel list and
favourites list are deleted and the »Station search« menu is
displayed (see page 38).
Press »i« to finish the setting.
6
Switching the voltage for an active indoor
antenna on and off
An active indoor antenna with a signal amplifier can be powered
via the
»TERRESTRIAL
(max. 30 mA). However, only switch on the antenna voltage if the
antenna is an active indoor antenna with a signal amplifier with no
power supply of its own from a mains adapter or similar source.
Otherwise you may cause a short circuit and irreversibly damage
your antenna.
In the »Main Menu«, select »Installation« with »P-« or »P+«
1
and press »OK« to confirm.
Exit
Select »Channel search« with »P-« or »P+« and press »OK«
2
to confirm.
Select »Antenna supply« with »P-« or »P+« and then press
3
»OK«.
Caution!
If the message »Short circuit or overload at the antenna input«
appears, switch off the digital recorder immediately using the
power switch and rectify the problem. The antenna has an
excessive current consumption (max. 30 mA) or a short circuit.
Exit
Press »P-« or »P+« to switch the antenna voltage on or off and
4
then press »OK« to confirm.
Press »i« and then »OK« to save the settings.
5
IN« connection with a +5 V DC supply
_________________
37
Advertisement
Table of Contents
