Rectifying Minor Problems - Grundig DTR 2544 User Manual

34
INFORMATION

Rectifying minor problems

If a fault occurs, first refer to this information before you take the digital
receiver for repair.
If you are unable to rectify the fault using the information given here, contact
your local dealer or service specialist.
Under no circumstances should you attempt to repair the digital receiver
yourself, as this will invalidate the guarantee.
PROBLEM POSSIBLE CAUSE
No function, mode Power cord incorrectly
indicator not lit connected
No picture Euro-AV (Scart) cable not
properly connected, incorrect
settings in the
»Device connections« menu
No sound The sound is muted, the
Euro-AV cable is incorrectly
connected or the receiver
volume is set to low
Message: »Faulty The antenna is not properly
signal« connected or positioned
The remote control No batteries are inserted,
does not work. or they are low, or the remote
control is not directed at the
infrared sensor
The time is not Deviation from the local time
correctly displayed
Message: »Short The antenna has an excessive
circuit or overload at current consumption or a short
the antenna input« circuit.
___________________________________________
REMEDY
Connect the power cord
correctly
Connect the Euro-AV cable
correctly, correct the menu
settings
Switch on the sound,
connect the Euro-AV cable
correctly, turn up the
volume
Connect the antenna
correctly. Move the antenna
around to find the best
position
Insert the batteries
correctly, put in new
batteries, point the remote
control at the infrared
sensor
Correct the difference
Switch off/unplug the
device immediately.
Disconnect the antenna,
go to the »Channel
search«, set the »Antenna
supply« to »Off« and save
this setting.