Table of Contents
Advertisement
Menu language
Deutsch
Language
English
Français
Italiano
Español
Suomi
Svenska
Select
Back
and confirm
Installation
Menu language
Channel search
Video output
Time
Special functions
Info
Select
Back
and open
Channel search
Australia
Raster/Country
Off
Antenna supply
Automatic search
Manual search
Select
Back
and open
ADDITIONAL FUNCTIONS
Setting the menu language
Press »i« to open the main menu.
1
Select »Installation« with »P-« or »P+« and press »OK« to
2
confirm.
3
Select »Menu language« with »P-« or »P+« and press »OK«
to
confirm.
4
Select the »Language« setting with »OK«.
5
Select your language using »P-« or »P+« and press »OK« to
confirm.
Press »i« and then »OK« to save the settings.
6
Switching the voltage for an active indoor
antenna on and off
An active indoor antenna with a signal amplifier can be powered
via the
»TERRESTRIAL
(max. 30 mA). However, only switch on the antenna voltage if the
antenna is an active indoor antenna with a signal amplifier with no
power supply of its own from a mains adapter or similar source.
Otherwise you may cause a short circuit and irreversibly damage
your antenna.
1
In the main menu, select »Installation« with »P-« or »P+« and
press »OK« to confirm.
Exit
Select »Channel search« with »P-« or »P+« and press »OK«
2
to confirm.
3
Select »Antenna supply« with »P-« or »P+« and then press
»OK«.
Caution!
If the message »Short circuit or overload at the antenna input«
appears, switch off the digital receiver immediately using the
power switch and rectify the problem. The antenna has an
excessive current consumption (max. 30 mA) or a short circuit.
Exit
Press »P-« or »P+« to switch the antenna voltage on or off and
4
then press »OK« to confirm.
Press »i« and then »OK« to save the settings.
5
Raster/country
This setting is for your information only and cannot be changed.
IN« connection with a +5 V DC supply
_________________
25
Advertisement
Table of Contents
