NetComm NB16DG User Manual page 57

Routing
Routing tables allow you to determine which physical interface address to use for outgoing IP data. If you have more than one
router and subnet, you will need to configure the routing table to allow packets to find the proper routing path and allow different
subnets to communicate with each other.
These settings are used to setup the static and dynamic routing features of the NB16DG.
Dynamic Routing:
Routing Information Protocol (RIP) will exchange information about different host destinations for working out routes throughout
the network.
Note: Only select RIPv2 if you have a different subnet in your network. Otherwise, select RIPv1.
Static Routing:
For static routing, you can specify up to 8 routing rules.
You need to enter the destination IP address, subnet mask, gateway, and hop for each routing rule, then enable the rule by
selecting the Enable checkbox.
Click the Save button to store your setting or the Undo button to discard your changes.
NetComm Wireless NB16DG User Guide
57
www.netcommwireless.com