Checking The Serverboard Setup - Supermicro 6027TR-H70QRF User Manual

2-6

Checking the Serverboard Setup

After you install the SuperServer 6027TR-H70QRF/H70FRF/H70RF in the rack, you
will need to open the unit to make sure the serverboard is properly installed and all
the connections have been made.
Accessing the inside of the System
Before operating the server for the fi rst time, it is important to remove the protective
fi lm covering the top of the chassis, in order to allow for proper ventilation and
cooling.
Removing the Chassis Cover and Protective Film (Figure 2-5)
1. Remove the two screws which secure the top cover onto the chassis as
shown above.
2. Lift the top cover up and off the chassis.
3. Peel off the protective fi lm covering the top cover and the top of the chassis
4. Check that all ventilation openings on the top cover and the top of the chassis
are clear and unobstructed.
Figure 2-5. Accessing the Inside of the System
3
1
1 1
Remove two screws
2-9
Chapter 2: Server Installation
1 2
4
1
Check Ventilation
Openings