Connecting The Headphones; Connecting The Power Cord; Inserting Batteries In The Remote Control - Grundig Oslo CDS 6690 USB User Manual

CONNECTION AND PREPARATION

Connecting the headphones

1 Insert the headphone plug (ø 3,5 mm) into the »
socket on the right side of the hi-fi.
– The loudspeakers of the hi-fi system are switched
off.
Note:
Excessive sound pressure from the earphones or
7
headphones can cause hearing loss.

Connecting the power cord

Note:
Check that the mains voltage on the type plate (on
7
the bottom of the hi-fi system) corresponds to your
local mains supply.
1 Plug the mains cable supplied into the
ket on the hi-fi system.
2 Plug the power cord into the wall socket.
Caution:
The hi-fi system is connected to the mains with the
7
power cord. Pull out the power cord when you
want to completely disconnect the hi-fi system
from the mains.
Unplug the mains plug to disconnect the hi-fi sys-
7
tem from the mains. Make sure the power plug is
easily accessible during operation and not hinde-
red by other objects.
36
ENGLISH
Inserting batteries in the remote
control
U
«
1 Open the battery compartment by pushing down its
lid.
2
When inserting the batteries (2 x 1.5 V, R 6/UM 3/
AA), observe the polarity marked on the base of the
battery compartment.
Note:
Do not expose the batteries to extreme heat, cau-
7
sed for example by direct sunlight, heaters or fire.
If your hi-fi system no longer reacts properly to re-
7
»AC ~ « soc-
mote control commands, the batteries may be flat.
Always remove used batteries. The manufacturer
accepts no liability for damage resulting from le-
aking batteries.
Environmental note:
Batteries, including those which contain no heavy
7
metal, should not be disposed of with household
waste. Please dispose of used batteries in an envi-
ronmentally responsible manner. Find out about
the legal regulations which apply in your area.
_____________________