Troubleshooting - Grundig Oslo CDS 6690 USB User Manual

INFORMATION

Troubleshooting

Not every kind of sound interference is caused by a de-
fect in your hi-fi system. Defects can also be caused by
leads having been accidentally pulled out, damaged
CDs and worn out batteries in the remote control. If the
following measures do not do not rectify the problem,
consult an authorised dealer.
Fault
No sound.
The hi-fi system does not react
when the buttons are pressed.
The remote control does not
work.
Poor radio reception.
Tracks on a CD are skipped.
CD-Rs or CD-RWs are not
played back, or are played
back incorrectly.
52
ENGLISH
_____________________________________________________
Possible cause/remedy
The volume setting is too low – increase the volume.
The headphones are plugged in – disconnect the headphones.
The power cord is incorrectly connected. Connect it properly.
Mute is activated, deactivate Mute.
Static electrical discharge. Switch off the hi-fi system, disconnect the power
cable and plug it in again after a few seconds or press »RESET«.
The batteries are flat. Replace the batteries.
The remote control is out of range of the stereo.
Weak antenna signal, check the antenna.
Weak FM-stereo signal, switch to Mono.
Interference from electrical devices such as televisions, video recorders, com-
puters, neon lamps, thermostats or motors. Keep the hi-fi system away from
such devices.
The CD is damaged or dirty – replace the CD or clean it.
The PROGRAM (track memory) or RANDOM functions are active. Deactivate
the functions.
Faulty software or hardware settings during burning or the CD itself. Check
the components of your CD burner/software or change the CD being used.