Changing The Network Configuration - Alcatel OMNISTACK 6148 User Manual

Using the System Configuration Program

Changing the Network Configuration

Use the Network Configuration menu to set the bootup option, configure the switch's
Internet Protocol (IP) parameters, enable the on-board Web agent, or to set the
number of concurrent Telnet sessions allowed. The screen shown below is
described in the following table.
<Apply>
Use <TAB> or arrow keys to move. <Enter> to select.
Parameter
IP Configuration
IP Connectivity Test (Ping)
HTTP Configuration
MAX Number of Allowed Telnet
Sessions
Physical Address
2-10
Alcatel OmniStack 6148
< Network Configuration >
IP Configuration
IP Connectivity Test(Ping)
HTTP Configuration
MAX Number of allowed Telnet sessions (1-4) : 4
Physical Address : 99-99-99-23-44-57
<Ok>
Description
Screen used to set the bootup option, or configure the switch's IP
parameters.
Screen used to test IP connectivity to a specified device.
Screen used to enable the Web agent.
The maximum number of Telnet sessions allowed to simultaneously
access the agent module.
Physical address of the agent module.
<Cancel>