Table of Contents
Advertisement
Chapter 2: Using the System Configuration Program
Login Screen
Once a direct connection to the serial port or a Telnet connection is established, the
login screen for the on-board configuration program appears as shown below.
Copyright (c), 2002 Alcatel and its licensors.
OmniStack is a trademark of Alcatel registered in
the United States Patent and Trademark Office.
If this is your first time to log into the configuration program, then the default user
names are "admin" and "user," both with a default password of "switch." The
administrator has Read/Write access to all configuration parameters and statistics.
The user has Read Only access to the management program.
You should define a new administrator password, record it and put it in a safe place.
Select Console Login Configuration from the Management Setup Menu and enter a
new password for the administrator. Note that passwords can consist of up to 11
alphanumeric characters and are not case sensitive.
Notes: 1. Based on the default configuration, a user is allowed three attempts to enter
the correct password; on the third failed attempt the current connection is
terminated.
2. A banner message may be configured to appear before the Login screen.
The banner message is a login security alert. (See "Configuring the Banner
Message" on page 2-22.)
Alcatel OmniStack 6148
Alcatel Internetworking
26801 West Agoura Road
Calabasas, CA, 91301
(818) 880-3500
Alcatel OmniStack
All rights reserved.
Username :
Password :
2-1
Hide quick links:
Advertisement
Table of Contents
