Honeywell Dolphin 7850 User Manual page 133

Using the Comm/Charge Cable
1. Plug the cable's terminal connector into the I/O connector on the bottom panel of the terminal.
2. Tighten the jackscrews.
3. Plug the power cable connector into the power cable.
4. Plug the power adapter on the power cable into a standard power outlet.
5. Plug the communication connector into the host workstation.
6. Establish the ActiveSync Communication (see page 12-5).
ActiveSync Communication
After the terminal is connected to a power source and the host workstation, you need to set up both the
terminal and the host workstation for ActiveSync communication.
Setting up ActiveSync for the comm/charge cable is the same as for the Dolphin HomeBase device, which
also has a USB and an RS-232 version. For details, see Using ActiveSync on page 7-3.
Default ActiveSync Communication Values
The default workstation synchronization value for USB communication is 'USB Connection.
The default workstation synchronization value for RS-232 communication is '115200 Default.
12 - 5