Charging The Main Battery - Honeywell Dolphin 7850 User Manual

Charging the Main Battery

The base powers the terminal and fully charges its main battery pack in less than four(4) hours. To check
battery power, see Power
As battery packs charge, the charging circuitry follows the two-step charging process (CC-CV) that is
recommended for Li-ion batteries. This process monitors changes in temperature, current, and voltage.
Inserting a Terminal
1. Install the battery pack in the terminal; see
Pack on page 2-1.
2. Power the base; see
3. Slide the terminal into the terminal well until the Dock LED lights
green to indicate that the terminal is properly seated.
4. The battery pack begins charging.
The intelligent battery charging system in the terminal monitors battery
power and senses when a full charge has been obtained. When
charging is complete, the terminal switches to a trickle charge that
keeps the battery at full charge while resting in the base.
on page 6-12.
Power on page 9-5.
Install the Main Battery
9 - 7