Power - Honeywell Dolphin 7850 User Manual

Power

The terminal requires 9.5 volts DC input for communication and battery charging; the power adapter on
the power cable converts the voltage from the power source to 9.5 volts DC. Only power adapter cables
from Honeywell convert the voltage appropriately.
Power Cable
Power Adapter
1. Plug the power cable into the power adapter.
2. Plug the power cable into the power source.
3. Plug the connector cable into the DC power jack on the back panel. The base is now powered.
When a terminal is properly seated in the terminal well, the base powers the terminal, charges the
terminal's main battery pack, and launches ActiveSync communication (see
on page 9-8).
Honeywell recommends that you leave the base connected to its power source at all times, so that it is
always ready to use.
Plug this connector into the
DC Power Jack on the back
panel.
ActiveSync Communication
9 - 5