Table of Contents
Advertisement
GS-R1271-RH Rack Mount Server
Step 2-5: PCI Expansion Card Installation
GS-R1271-RH provides expansion riser slots for two PCI-E x8 slot. To install the peripheral, please go
through the following steps.
Note!!
Before installing the expansion card, please check the card size limitation. Size limitation for
standard riser card is 182mm; and the size limitation for low profile riser card is 182mm.
Step 1 Loosen the riser bracket screws.
Step 2 Lift the riser bracket slightly, then pull it out from the server chassis.
Step 3 Unlock the screw on the riser bracket to remove the PCI bracket. Align the expansion card with
the guiding groove. Slide the expansion card into the slot until the card firmly seats.
Step 4 Reverse step 1 to 3 to reinstall riser bracket into the system module.
3
1
2
1 5
3
Advertisement
Table of Contents
