Evaluating Synchronisation Signals; Adjusting The Picture - Grundig PlanaVision 42 PXW 110-8620 Dolby User Manual

OPERATION AS A PC MONITOR
PC YUV settings
A
1 Input Information
2 User timings
3 Auto Setup
4 V Pos. :
5 V Size :
6 H Size:
7 H Pos. :
S
Select
and open
Back End
PC YUV settings
A
1 Input Information
2 User timings
3 Auto Setup
4 V Pos. :
5 V Size :
6 H Size:
7 H Pos. :
S
Select
and open
Back End
Settings
1 Display Source Info : On
2 Language
3 OSD Set Up
4 Pwr Down/Stand-By
5 Reset to factory Defaults
6 Repeat initial installation
7 Sleep Timer : Off
Select
and open
Back End
3 Select »Main input« Press »P+« or »P-« to select, and then press » « or
» « » to select PC (YUV)«, »PC (RGB)« or »PC (DVI)«.
4
Select »Main input settings« by pressing »P+« or »P-« and press »OK« to
confirm.
– The first two lines are information about the PC.
Note:
The other settings are explained in the following sections.

Adjusting the picture

1
Select »Auto Setup« with »P+« or »P-« and confirm with »OK«.
Note:
With the »V Pos«, »V Size«, »H Size«, »H Pos« and »Phase« settings, you
can customise the picture of the PC.
Select with »P+« or »P-« and press » « or » « to implement the setting.
2
Press »i« to finish the settings.
User formats
If different PCs are connected to the television, you can assign user formats.
1
Select »User timings« with »P+« or »P-« and confirm with »OK«.
Note:
With the »V Pos«, »V Size«, »H Size«, »H Pos« and »Phase« settings, you
can customise the picture of the PC.
Select with »P+« or »P-« and press » « or » « to implement the setting.
2
Press »i« to finish the settings.

Evaluating synchronisation signals

If this function is activated, the device automatically switches to standby when a
signal is detected at the
preset channel »PC (RGB)« or »PC (DVI)« has been selected.
1 Press »i« to open the main menu.
2
Select »Set Up« with »P+« or »P-« and confirm with »OK«.
3
Select »Pwr Down/Stand-By« with »P+« or »P-« and confirm with »OK«.
4
Select »Reaction on PC syncs« with »P+« or »P-« and switch off or on with
» «.
5
Press »i« to finish the settings.
___________________________________________
»PC DVI-I« socket. The condition for this is that the
25