Billion BiPAC 7402NX User Manual page 79

PPPoE
PPPoE (PPP over Ethernet) provides access control in a manner which is similar to dial-up services
using PPP.
Profile Port: Select the profile port
Username: Enter the username provided by your ISP. You can input up to 128 alphanumeric characters
(case sensitive). This is in the format of "username@ispname" instead of simply "username".
Password: Enter the password provided by your ISP. You can input up to 128 alphanumeric characters
(case sensitive).
Service Name: Enter a name for this connection.
IP: Your WAN IP address. Leave this at 0.0.0.0 to automatically obtain an IP address from your ISP.
Connection:
Always on: If you want the router to establish a PPPoE session when starting up and to
automatically re-establish the PPPoE session when disconnected by the ISP.
Connect on Demand: If you want to establish a PPPoE session only when there is a packet
requesting access to the Internet (i.e. when a program on your computer attempts to access the Internet).
Idle Timeout: Auto-disconnect the router when there is no activity on the line for a predetermined period
of time.
MTU: Maximum Transmission Unit. The size of the largest datagram (excluding media-specific headers)
that IP will attempt to send through the interface.
NAT: The NAT (Network Address Translation) feature allows multiple users to access the Internet through a
single IP account, sharing the single IP address. If PCs in LAN should share the WAN IP for WAN access,
please enable NAT. If users on your LAN have public IP addresses and can access the Internet directly, the
NAT function can be disabled.
Auth. Protocol: Default is Auto. Your ISP advises on using Chap or Pap.
MAC Spoofing: Select Enable and enter a MAC address that will temporarily change your router's MAC
address to the one you have specified in this field. Leave it as Disabled if you do not wish to change the
MAC address of your router.
Obtain DNS: Select Automatic to use DNS.
Primary DNS/ Secondary DNS: Enter the IP addresses of the DNS servers. The DNS servers are
passed to the DHCP clients along with the IP address and the subnet mask
IPv6: check to enable IPv6 service. Enter IPv6 Gateway address and set IPv6 DNS as same in IPv4
mode.
Chapter 4: Configuration
Billion BiPAC 7402NX(L) 802.11n 3G/ADSL2+ (VPN) Firewall Router
as .
EWAN
75