Billion BiPAC 7402NX User Manual page 119

802.11n 3g/adsl2+ (vpn) firewall router
Hide thumbs Also See for BiPAC 7402NX:
Table of Contents

Advertisement

from 5 to 15,000 minutes, and the default is 480 minutes.
 Phase 2 (IPSec): To negotiate and establish secure authentication. The range can be from 5 to
15,000 minutes, and the default is 60 minutes.
A short SA time increases security by forcing the two parties to update the keys. However, every
time the VPN tunnel re-negotiates, access through the tunnel will be temporarily disconnected.
PING for Keep Alive:
None: The default setting is None. To this mode, it will not detect the remote IPSec peer has
been lost or not. It only follows the policy of Disconnection time after no traffic, which the remote IPSec
will be disconnected after the time you set in this function.
PING: This mode will detect the remote IPSec peer has lost or not by pinging specify IP address.
DPD: Dead peer detection (DPD) is a keeping alive mechanism that enables the router to be
detected lively when the connection between the router and a remote IPSec peer has lost. Please be
noted, it must be enabled on the both sites.
PING to the IP: It is able to IP Ping the remote PC with the specified IP address and alert when the
connection fails. Once alter message is received, Router will drop this tunnel connection. Re-establish of
this connection is required. Default setting is 0.0.0.0 which disables the function.
Interval: This sets the time interval between Pings to the IP function to monitor the connection status.
Default interval setting is 10 seconds. Time interval can be set from 0 to 3600 second, 0 second disables
the function.
Ping to the IP
xxx.xxx.xxx.xxx (A valid IP Address)
xxx.xxx.xxx.xxx(A valid IP Address)
Disconnection Time after no traffic: It is the NO Response time clock. When no traffic stage time is
beyond the Disconnection time set, Router will automatically halt the tunnel connection and re-establish it
base on the Reconnection Time set. 180 seconds is minimum time interval for this function.
Reconnection Time: It is the reconnecting time interval after NO TRAFFIC is initiated. 3 minutes is
minimum time interval for this function.
Click Edit/Delete to save your changes.
Chapter 4: Configuration
Billion BiPAC 7402NX(L) 802.11n 3G/ADSL2+ (VPN) Firewall Router
0.0.0.0
0.0.0.0
Interval (sec)
0
2000
0
2000
Yes, activate it in every 2000
Ping to the IP Action
No
No
No
second.
115

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bipac 7402nxl

Table of Contents