Table of Contents
Advertisement
28 electrolux what to do if...
Fault codes and malfunction
• continuous flashing of the light of the
running programme
• 2 flashes of the End indicator light
The dishwasher will not drain
• continuous flashing of the light of the
running programme
• 3 flashes of the End indicator light
Anti-flood device is activated
Malfunction
The programme does not start
Once these checks have been carried
out switch on the appliance.
The programme will continue from the
point at which it was interrupted.
If the malfunction or fault code reap-
pears contact your local Service Force
Centre.
For other fault codes not described in
the above chart, please contact your lo-
cal Service Force Centre.
Contact your local Service Force Centre,
quoting the model (Mod.), product num-
ber (PNC) and serial number (S.N.).
Possible cause and solution
• The sink spigot is blocked.
Clean out the sink spigot.
• The water drain hose has not been
correctly laid or it is bent or squashed.
Check the water drain hose connec-
tion.
• Close the water tap and contact your
local Service Force Centre.
Possible cause and solution
• The dishwasher door has not been
properly closed.
Close the door.
• The main plug is not plugged in.
Insert the main plug
• The fuse has blown out in the house-
hold fuse box.
Replace the fuse.
• Delay start has been set.
If dishes are to be washed
immediately, cancel the delay start.
This information can be found on the rat-
ing plate located on the side of the
dishwasher door.
So that you always have these numbers
at hand, we recommend you to make a
note of them here:
Mod. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PNC : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Advertisement
Table of Contents
