Create New Exercises With Polar Protrainer 5; Wear The Heart Rate Sensor - Polar Electro CS600X User Manual

ENGLISH
1. : Set the number of zones to 0.
Number of zones
2. : Choose to sound a timer during workout (reminding you to drink, for example), or set a
Guide type
distance (for following lap times without recording them).
Timers
• : Choose the number of timers (1-3) for the session. Press OK.
Number of timers
• : Define minutes and seconds for the timer and press OK.
Timer 1
Distances
• : Choose the number of distances (1-3) for the session. Press OK.
Number of distances
• : Enter the distance(s) and press OK.
Distance 1
Repeat step 2 until you have defined timers or distances. When the exercise is ready,
is displayed. The new exercise (
next exercise. Rename the exercise by selecting Rename from the list.
* Optional sensor required.

Create New Exercises with Polar ProTrainer 5

Create more diversified exercises by using Polar ProTrainer 5. For further information, consult Polar
ProTrainer 5 help.

Wear the Heart Rate Sensor

Wear the heart rate sensor to measure heart rate.
1. Moisten the electrode area of the strap.
In demanding conditions e.g. during long-lasting events, we recommend using conductive electrode lotion or
gel to improve the contact, after which, it is very important to wash the heart rate sensor carefully.
2. Attach the connector to the strap.
3. Tie the strap around your chest, just below the chest muscles, and attach the hook to the other end of
the strap.
4. Adjust the strap length to fit tightly but comfortably. Check that the moist electrode areas are firmly
against your skin and that the Polar logo of the connector is in a central and upright position.
Detach the connector from the strap after every use, to maximize the battery lifetime. Sweat and moisture may
keep the electrodes wet and the heart rate sensor activated. This will reduce the battery life. For more detailed
washing instructions, see Care and Maintenance (page 61).
14 Prepare for Training
) is stored in the Exercises menu, where you can select it for your
NewExe
New exercise added