Table of Contents
Advertisement
72 electrolux
Electrical connection
The unit is preset to work with a
voltage of single phase 230 V.
Before making the connection make
sure that:
- the energy power available in the
user's house is sufficient for the nor-
mal supply of this appliance (see
rating plate).
— the unit is correctly connected to
earth through a suitable plug and
according to the installation country
Laws.
— the socket or the omnipolar switch
used for the connection must be
easilv reached with the installed
appliance.
The appliance is supplied with
electric cable, therefore you will have to
fit it with a standard plug, suitable for the
total electric load shown on the rating
plate. The plug isto be inserted into a
suitable wall socket.
If you wish to directly connect to the
mains, you have to interpose an
omnipolar switch with a minimum
opening between contacts of 3 mm,
between the unit and the mains,
complying with the existing regulations.
The brown live wire (originating from the
clamp of the cooker junction box) must
always be connected to the phase of the
mains supply. In any case, the supply
cord must be positioned in such a way
as it doesn't reach in any point a
temperature higher by 50°C than the
room tem- perature.
Should the supply cord need to be
replaced, use only the following cable
types:
H05RR-F / H05VV-F / H05V2V2-F
(T90). It is necessary that the yellow/
green earth wire is about 2cm longer
than the live and neutral ones.
After the connection, test the heating
elements for about 3 minutes to ensure
that they are working correctly.
The manufacturer refuses any res-
ponsability in cases where normal
safety measures are not observed.
Phase
FO 0073
Neutral
wire
Ground (yellow - green)
Advertisement
Table of Contents
