DSC PC5502Z2 Instruction Manual page 3

U s i n g t h e P C 5 5 02 Z 2
The PC5502Z2 keypad uses lights and sounds to indicate the status of your security system.
This manual describes the basic features of the keypad. Please review it thoroughly.
1. Zone Lights
Lights 1 and 2 show the status of zones 1
and 2 on your system. For example, these
lights will be on when the zones are open, or
when the zones are in alarm.
2. Status Lights
Ready Light
If the Ready light is ON, the system is ready
for arming. The system cannot be armed
unless the Ready light is ON.
Armed Light
If the Armed light is ON, the system has been
armed successfully.
System Light
If the System light is ON, one or more of
these conditions could be present on the sys-
tem:
System troubles: If a trouble condition
occurs, the keypad will beep twice every 10
seconds until you press any key on the key-
pad.
NOTE: A Trouble condition reduces the
security your system is designed to provide.
Call your installing company for service.
Alarms in memory: See "Disarming the Sys-
tem".
Zones are bypassed: See "Bypassing Zones".
Programming: The System light will flash
when you are programming access codes, or
performing other programming functions. If
someone is programming at another keypad,
the System light will turn ON to indicate that
the system is busy.
3. Number Pad
Use the number pad to enter your code, and
to access system functions. To exit a function
and return to the Ready state, press
select a function press
4. Function Buttons
If your installer has enabled them, you can
use the function buttons to access the stay
arm, away arm, door chime, sensor reset and
quick exit features. Press and hold the appro-
priate button for two seconds.
5. Emergency Keys
Press both * keys for two seconds to send
a FIRE message. Press both
seconds to send an AUXILIARY message.
Press both * keys for two seconds to send
a PANIC message.
* IMPORTANT NOTE: The Fire, Auxiliary
and Panic keys will NOT function unless
programmed by the installer. If these
keys are in service, when you hold down
both keys for two seconds the keypad
sounder will beep, indicating that the
input has been accepted and sent.
. To
.
* keys for two
1