Table of Contents
Advertisement
NOTE: You will not be able to enter areas protected by motion detectors, or open
doors or windows protected by door/window contacts. To access these areas, you must
enter your [access code] and disarm the system.
Arming your security system – other methods
Quick Arm
Your installer will tell you if Quick Arming has been enabled on your system. This is a fast way
to Away arm your system.
To quick arm:
1.
Check that the system is ready to be armed.
2.
Press
. You do not need to enter your access code. The exit delay begins and the keypad
beeps.
3.
Exit the premises through the entry/exit door.
At the end of the exit delay, all keypad lights, except the Armed light, turn OFF. The system is
now armed.
NOTE: Pressing
[access code].
NOTE: This feature is not enabled on UL listed systems. See your Installer for more
information.
No Entry Arming
If you want to fully arm the system, and no one else will be entering, you can remove the entry
time from zones that normally have one. An entry through any zone will create an instant
alarm.
1.
Check that your system is ready to be armed.
2.
Press
, then your [access code].
The Armed light will flash as a reminder that the system is armed and has no entry delay.
Exiting when system is armed
When the Quick Exit feature is enabled, pressing
vide a two minute window for you to exit the premises. During this time, you may only
open and close the designated Entry/Exit door once. Once the door is closed, the panel
will end the two minute quick exit delay. If the door is opened again, or if the door is not
closed after two minutes, or if another zone is opened, the panel will begin the entry delay.
Your installer will inform you if the Quick Exit feature has been enabled on your system.
Turning off your system (Disarming)
1.
Enter the premises through the designated entry/exit door. The keypad beeps to indicate that
you must disarm the system.
NOTE: Entering by any other door will immediately cause an alarm.
2.
Go to the keypad and enter your [access code]. You must enter a valid access code before the
entry time expires. If a valid access code is not entered during this time, the system will sound an
alarm.
As soon as the correct code is entered, the Armed light goes out and the keypad stops beeping.
If you entered the access code incorrectly, the keypad sounder buzzes steadily for two seconds.
Re-enter your access code correctly.
will only arm the system. To disarm, you must enter a valid
E x i t i n g w h e n s y s t e m i s a r m e d
while the system is armed will pro-
3
Advertisement
Table of Contents
