Table of Contents
Advertisement
22 electrolux
Installation Instructions
Built-in cooker SMS width 55 cm
Installation into flammable material must
comply with NIN 2005, Chapter 4.2.2 of
the VKF (Association of Cantonal Fire In-
surers) fire protection guidelines and
regulations.
1. a) Install the hotplates according to the
installation insruction no.374307900/
374307901 so that the hotplate socket
connections can be carried out before
the cooker is inserted. Make sure the
correct socket connections are used.
A seperate earthing is not required
b) Install the glass ceramic cooking sur-
face and hobs according to the sepa-
rate installation instructions.
2.
Pull the appliance drawer out as far as it
will go, take hold of it and remove it.
3.
Hold the oven by the carrying using the
side grips and slide it flush into the
space.
4.
Fix the oven on both sides using at least
2 screws (Detail A).
For safety reasons, when installing next
to a wood-fuelled boiler, a heatproof and
heat-insulating plate must be mounted
at the height of the appliance and must
be installed with a depth of at least
30 cm.
To secure it, you can bore 2 x 2.8mm
holes at the top where the indents are
provided (detail C).
Electrical connection/power supply
The oven must be connected to the electric-
ity supply by a designated electrician.
Use a H05VV-F type power cable or higher.
The appliance must be installed with a sock-
et supply line, otherwise the fixed home elec-
trical system must include an isolating device
with at least a 3mm-contact separation to
enable a simultaneous and all-pole cut off
from the mains, according to NIN 2000.
The customer must have a socket for the
electrical connection that is accessible and
outside the co-ordination room. A cable
length of approx. 120 cm must be provided
with lines connected direct to the mains.
Advertisement
Table of Contents
