Installing Hardware Options; Installing An Optional Tray Or Drawer - Lexmark 131 User Manual

Additional printer setup

Installing hardware options

Installing an optional tray or drawer

The printer supports two additional input sources: an optional 550‑sheet tray and a 650‑sheet duo drawer (Tray 2) with
an integrated multipurpose feeder.
Note: Some printer models may not support the optional 550‑sheet tray.
CAUTION—POTENTIAL INJURY: The printer weight is greater than 18 kg (40 lb) and requires two or more
trained personnel to lift it safely.
CAUTION—SHOCK HAZARD: If you are accessing the system board or installing optional hardware or memory
devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the
wall outlet before continuing. If you have any other devices attached to the printer, then turn them off as well,
and unplug any cables going into the printer.
1
Unpack the optional 550‑sheet tray, and then remove all packing material and the dust cover.
2
Place the tray in the location chosen for the printer.
Note: If you are installing both the optional tray and the 650‑sheet duo drawer, the optional 550‑sheet tray
must always be installed as the first tray (configuring from the bottom up).
3
Align a 650‑sheet duo drawer with the optional 550‑sheet tray, and then lower it into place.
29