Fitting The Carbon Filter - Electrolux EFC 959 User Manual

Mounting the cold air valve (Fig. 10):
Not applicable for recirculation. The hood can be fitted
with a cold air valve. The cold air valve consists of two
valves fitted into the hood outlet. If there is no other
form of ventilation to expel air from the kitchen than the
hood, the outer end of the valves should be clipped off
and removed. Bend the valves so that the guides slide
into the attachment holes in the hood outlet. Make sure
the spoke-pattern side of the valves faces upwards.
Insert a pen or something similar between the valves.
These should open up easily now. If they do not, check
that neither of the valves is upside down or has come
out of the attachment hole.
Mounting the venting kit (Fig. 11):
A complete venting kit is available as an optional extra.
The ventilation pipe (A) is pulled over the hood's
evacuation flange (B) and is held firmly in place with a
clamp. Make sure the pipe is as straight as possible
and does not hinder the movement of the valve flaps.
The pipe is connected to the mouth of the duct with the
metal flange (C) which is included in the kit.

Fitting the carbon filter

Only applicable for recirculation. The LONG LIFE
carbon filter (special accessory) for this hood is fitted
instead of the grease filter. The LONG LIFE carbon
filter is both a grease and carbon filter for reduction of
cooking smells.
Fig. 10
Extend the duct hose correctly. A duct
hose which is too long or has too many
bends can reduce cooker hood efficiency
by fifty per cent. Shorten the hose if it is
too long, and avoid unnecessary bends in
it.
Fig. 11