Installing The Duct For Exhausting Version; Installing The Duct For Recycling Into The Room (Carbon Filter Version); Mounting Of Carbon Filter - Electrolux EFC 635 X User Manual

Installing the duct for exhausting
version
Fasten the top support H (fig. 9) to the wall
close to the ceiling on the perpendicular of the
bottom connections. To do use the two Ø 5x45
screws and Ø 8mm plugs supplied as standard
equipment.
Mount the evacuation flex tube on the outlet A
fig. 2.
If a no return valve is used check that it can
open correctly and is not blocked by the flex
tube
Take the measure h (fig. 9) between the ceiling
and the hood top, and adjust the duct to this
height. Fasten it with the screws M (fig. 9).
Insert the duct with the slots downwards and
fasten it with the two top screws and the two
bottom screws K (fig. 9).
On the version EFC 935 X check that the two
internal shutters S (Fig. 9) are open.
Installing the duct for recycling
into the room (Carbon filter
version)
Perform the same operations described in the
preceding paragraph with regards to:
Fastening of top support H
Adjustment of duct
If a no return valve in duct A (fig. 2) is
mounted it should be removed.
Before mounting the duct, fasten, with the
screws supplied, the air conveyor N inside
the duct (fig. 10).

Mounting of carbon filter

Remove the grease filter by pushing it towards
the back of the hood and pulling it downwards.
The hood with the denomination EFC 935 X has
two internal shutters S (fig. 11) behind the
grease filter. These are at delivery open. Before
mounting the carbon filter they should be shut.
M
s
Fig. 9
Fig. 10
s
Fig. 11
45
K
h
K
s
M
s
H
K
K
N