Table of Contents
Advertisement
3. Getting Started
Before you start, you should have:
One computer with Windows 98SE/Me/NT/2000/XP for normal printer
installation, if you are using GDI printer, please make sure your computer
with Windows 98SE/Me/2000 SP4 above/XP SP1 above
One GDI printer or general printer with USB port and an installation CD
One Category 5 Ethernet Cable
One USB Cable
3.1
Hardware Installation Procedure
1. Unpack the FPS-1011 package and verify that all the items listed in the
previous section are provided.
2. Plug the USB cable to the FPS-1011 with the GDI printer or general printer
that you want to share on the network.
3. Connect the FPS-1011 to your network by attached the network cable to the
network port of the FPS-1011.
4. Connect the power adapter to the FPS-1011. The FPS-1011 will perform the
Power-On-Self-Test (POST) after it is powered on. When the ACT LED is
unlighted, the FPS-1011 is ready.
1. You must use the power adapter shipped along with the
FPS-1011, do NOT use any other power adapter from other
sources.
2. To prevent the compatibility problem between FPS-1011
Note
and a few GDI printer or printer, it is recommended that
you power on the FPS-1011 before the GDI printer or
general printer.
3.2
Software Installation Procedure
You have to uninstall all the Print Server drivers and utilities if
Note
you have installed the previous version.
Insert Drivers and User's Manual CD into the CD-ROM drive to initiate the
1.
autorun program. Once completed a menu screen will appear
. Click on "Administrator Installation" hyper link to initiate the installation. Or
2.
you can click the "Start" button and choose "Run". (Suppose "E" is your
CD-ROM drive). When the dialog box appears, enter "E:\Utility\Setup.exe"
and press enter key. You will see the dialog box as below. Please click "Next"
to continue.
The "Print Server Utilities - InstallShield Wizard" is displayed, click "Next".
3.
9
Advertisement
Table of Contents
