Assembly - Pro-Form 800 Hr Heart Rate Control Elliptical User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the
included hex keys and your own phillips screwdriver , adjustable wrench , and
rubber mallet .
Use the drawings below to identify the small parts used for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST on page 26. The number following the key number is
the quantity needed for assembly. Note: Some small parts may have been preassembled. If a part is not in
the parts bag, check to see if it has been preassembled.
M10 Washer Spring Bracket
M10 Split Handlebar Washer
Washer (59)–7 (55)–2 (78)–2 Washer (35)–2
M4 x 19mm
M4 x 16mm
Screw (26)–2
Screw (52)–4
Wave Washer M10 Nylon Locknut
M8 Nylon Locknut
(33)–6
(38)–4
(43)–2
M10 Bolt Set (74)–2
M8 x 45mm Button Bolt (50)–4
M8 x 25mm Patch M10 x 25mm Button M10 x 27mm Patch M10 x 30mm
Screw (40)–2 Carriage Bolt (80)–2
Screw (56)–2 Screw (67)–3
M10 x 74mm Button Bolt (28)–2
M10 x 75mm Carriage Bolt (34)–4
5