Appendix A: Factory Default - Planet ICA-3550V User Manual

To recover the default IP address and password, please follow the following steps:
Remove the power and Ethernet cable.
• Take an electronic wire, plug one side of the wire into "Default" and the other side
into "GND" on the terminal block as the picture is shown below.
• Connect power to the camera again. It takes around 30 seconds to boot the
camera.
• Remove the wire and plug in the Ethernet cable after the camera finishes
booting.
•Re-login the camera using the default IP (http://192.168.0.20), and user name
(admin), password (admin)
5 Mega-pixel Outdoor IR PoE IP Camera

Appendix A: Factory Default

70
User's Manual of ICA-3550V