Prog Selector; Dsc Programming - Blaupunkt KOPENHAGEN RCR 45 Operating Instructions Manual

Fast Rewind
• Press FR.
At the beginning of the tape, the me-
chanism will automatically start play-
back.
Stopping Fast Rewind operation
• Press FF.
To switch to the other side of the
cassette tape:
Press both buttons simultaneously.
The display shows TR1-PLAY or TR2-PLAY.
Fast winding
FR : Fast rewind; stop by pressing FF.
FF : Fast forward; stop by pressing FR.

PROG selector

(To change the tape direction during
cassette playback)
• Press FR and FF simultaneously.
At the end of a tape side, the mechanism
changes directions automatically to play the
other side (Autoreverse). The display shows
"TR1-PLAY" for track (side) 1 or A or "TR2-
PLAY" for track 2 or B.
Notice:
If there is too much tension on the tape during
playback, the set may switch over by itself
before having reached the end of the tape
side. In this case check the condition of the
cassette tape. Sometimes it helps to rewind
it completely.

DSC programming

DSC (Direct Software Control) allows you to
customise certain programmable, basic set-
tings to suit your personal needs and prefe-
rences and then store them.
The basic settings for this audio equipment
were made at the factory. In the following you
can find an overview of these settings, so that
you can always reset to these if desired.
If you wish to alter any of the programming,
• press DSC.
The display will show you the adjusted con-
dition.
Use the rocker switch to select and adjust the
functions described in the following.
/ Select function
Adjust value –
Adjust value +
33