Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Blaupunkt KOPENHAGEN RCR 45
Summary of Contents for Blaupunkt KOPENHAGEN RCR 45
- Page 1 Radio / Cassette Kopenhagen RCR 45 Operating instructions...
-
Page 3: Table Of Contents
Contents Short instructions ......21 Reception of traffic announce- ments with RDS-EON ....29 Important notes ......24 Traffic announcement priority on/off ..29 Precautions ........... 24 Warning beep ........29 Traffic safety ......... 24 Switching the warning beep off ..29 Installation/Connection ...... -
Page 4: Short Instructions
Short instructions 1 On 2 LD GEO – Volume Loudness - When listening at a low To adjust the balance (left/right) and level, the Loudness function creates a fader (front/rear) with the rocker switch. more natural sound by boosting the low frequency range. - Page 5 4 DSC (Direct Software Control) 7 lo/dx : Display Use the DSC function to customise To alter the automatic seek tuning sen- Radio operation: certain programmable, basic settings to sitivity. suit your personal needs and prefe- If “lo” is displayed, the radio will only rences.
- Page 6 ; PROG button/Fast winding > 1, 2, 3, 4, 5, 6 - preset buttons @ TS - Travelstore You can store six stations on each me- To store the six most powerful stations To switch to the other side of the mory bank (I, II, T).
-
Page 7: Important Notes
Important notes Precautions B KeyCard theft-protection system C Rocker switch To operate the set it is necessary that Seek tuning Before starting to use your new car radio, you have inserted the KeyCard. please read the information on “Traffic safe- ty”... -
Page 8: Installation/Connection
Do not make further adjustments until you Use only the accessory and replacement dually store the following functions: have a correct KeyCard available. parts approved by Blaupunkt. Bass, treble, balance and fader settings, assignments of preset buttons, Loudness, Removing the KeyCard TA (traffic announcement volume), BEEP Never pull out the KeyCard directly. -
Page 9: Optical Indication For Extra Security
Radio operation with RDS (Radio Data System) • Press the KeyCard in, which releases The Radio Data System offers you more stored frequencies, the unit is automatically convenience when listening to FM radio sta- the card and puts it in the proper positi- searching for an alternative frequency. -
Page 10: Automatic Tuning
Manual tuning << >> • Press the REG button briefly. With this, the requirements for selecting sta- tions with << >> are fulfilled. When active, “REG ON” will be briefly dis- (prerequisite: AF is switched off!) played each time the radio is switched on. •... -
Page 11: Automatically Storing The Strongest Stations With Travelstore
Recalling stored stations Notice: To start the scan: Should you tune in a station which has alrea- • Press SC briefly. You can recall any stored station by pressing dy been stored before, the corresponding The scanned frequency or the station the corresponding preset button. -
Page 12: Switching From Stereo To Mono (Fm)
Reception of traffic announcements with RDS-EON Switching from stereo to mono Warning beep (Enhanced Other Networks) (FM) Many FM broadcasters provide their service If you leave the reception area of the traffic area with traffic messages at regular inter- If reception is poor, you may get better sound program station you are currently listening to, vals. -
Page 13: Adjusting The Traffic Message Volume
Traffic Memo (TIM) Recalling stored traffic This set is equipped with a digital speech If no such traffic program station is found announcements memory, allowing up to 4 traffic messages within approximately 30 seconds, tape repro- lasting a maximum of 4 minutes to be auto- duction will be interrupted and the system will •... -
Page 14: Tim Standby Mode When The Radio Is Turned Off
TIM standby mode when the Adjusting the TIM standby Confirm your entry by radio is turned off mode/TIM time • press the TIM button briefly. The TIM-TIME is stored. With this system it is possible to record inco- The TIM-TIME to be set corresponds to the TIM will be active 1.5 hours before and after ming traffic announcements automatically at planned departure time. -
Page 15: Warning
Tape operation Inserting a tape Warning • Switch off the radio and press TIM. The display briefly shows STBY OFF. The motor antenna could be damaged in • Turn on the set. The antenna will then remain retracted when a car wash. •... -
Page 16: Prog Selector
DSC programming PROG selector DSC (Direct Software Control) allows you to Fast Rewind customise certain programmable, basic set- (To change the tape direction during • Press FR. tings to suit your personal needs and prefe- cassette playback) At the beginning of the tape, the me- rences and then store them. - Page 17 TIME The current time will be Each alteration of this va- RM-OFF - The function is displayed, or it has to be lue is confirmed by a beep switched off. adjusted. tone of the corresponding For more information, see volume. LOCAL (lo) chapter “Traffic Memo...
-
Page 18: Overview Of The Dsc Factory Settings
Appendix Overview of the DSC factory Mechanism/cassette tapes Specifications settings To avoid possible problems, you should not Amplifier use cassette tapes longer than 60 or 90 Output power: 4 x 6 W RMS power TA VOL minutes (C60/C90). Store your tapes in a acc. - Page 19 Blaupunkt-Werke GmbH Bosch Gruppe 11/95 Pf K7/VKD 8 622 400 356...
Need help?
Do you have a question about the KOPENHAGEN RCR 45 and is the answer not in the manual?
Questions and answers