Adjusting The Traffic Message Volume; Traffic Memo (Tim); Recalling Stored Traffic Announcements - Blaupunkt KOPENHAGEN RCR 45 Operating Instructions Manual

If no such traffic program station is found
within approximately 30 seconds, tape repro-
duction will be interrupted and the system will
release a warning beep. To switch the beep
off, proceed as described above.
Adjusting the traffic message
volume
The volume of the warning beep and of the
current traffic message was pre-adjusted at
the factory. If you would like to alter the
setting, proceed as described under "DSC
programming - TA VOL".
30

Traffic Memo (TIM)

This set is equipped with a digital speech
memory, allowing up to 4 traffic messages
lasting a maximum of 4 minutes to be auto-
matically recorded.
As soon as "TP" is displayed, the system will
record all incoming traffic announcements of
the adjusted station.
If the priority for traffic announcements is
activated ("TA" lights up in the display), the
set will also record the traffic messages of the
traffic station program within the same radio
network (see also "Reception of traffic an-
nouncements with RDS-EON").
Depending on the length of the new traffic
bulletin, the oldest messages will be deleted.
If a message is longer than four minutes, the
system will display OVERFLOW after four
minutes of playback, and release a beep tone
to indicate that the message could only be
recorded partially.
Warning
The motor antenna could be damaged in
a car wash.
If you have installed a motor antenna, then
please take into account the corresponding
warning note at the end of this chapter.
Recalling stored traffic
announcements
• Press TIM briefly.
The display for example shows: NDR2 (sta-
tion name or frequency), then briefly
T4 14.30 (T4 = 4th traffic message, recor-
ded at 14:30). If four traffic messages were
recorded, then "T4" always represents the
most recent announcement, which will also
be played first.
Use the / rocker button to switch between
T1 and T4.
If you keep the / key pressed down, then
the text of the stored message is skipped
forward or backwards quickly.
In addition to this, the relevant time (min./
sec.) is shown in the display.
This makes it possible to find an important
item of information quickly.
By pressing << you can return to the begin-
ning of the current message.
You can terminate the message output by
pressing the TIM or >> key.