Assembly - NordicTrack T25.0 Treadmill User Manual

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking
belt is coated with high-performance lubricant. During shipping, some lubricant may be transferred to the top of
the walking belt or the shipping carton. This is normal and does not affect treadmill performance. If there is lubri-
cant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included hex key
wrench .
Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is
the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses
is the quantity needed for assembly. Note: Some small parts may have been preassembled. To avoid dam-
aging parts, do not use power tools for assembly. Extra hardware may be included.
#8 x 1/2" Ground
Screw (9)–1
3/8" x 1 1/4" Screw (8)–4
3/8" x 2 1/2" Screw (4)–2
1. Make sure that the power cord is unplugged.
Place a piece of cardboard below the rear of the
Frame (56) to protect the floor or carpet.
Attach the Left Wheel Cap (96) to the left side of
the Base (97) with two #8 x 3/4" Screws (1).
Attach the Right Wheel Cap (not shown) to
the Base (97) in the same way.
and your own Phillips screwdriver
#8 x 3/4" Screw
(1)–4
3/8" x 1 3/4" Bolt (6)–1
5/16" x 1"
Bolt (2)–4
3/8" Star
Washer (12)–14
3/8" x 2 3/4" Screw (7)–4
1
97
1
6
and adjustable
3/8" Nut (11)–2
3/8" x 2" Bolt (3)–1
56
96
Cardboard