Maintenance - Weber Performer Touch-N-Go Ignition Owner's Manual

Maintenance

After a period of nonuse we recommend that you
perform the following maintenance procedures for your
safety.
Check hose before each use of barbecue for nicks,
cracking, abrasions or cuts. If the hose
is found to be unserviceable, do not use the
barbecue. Replace using only Weber authorized
replacement parts. Order from Weber-Stephen
Products Co., Customer Service Center or an
authorized dealer.
CAUTION: If the barbecue gas hose is damaged in
any way or leaking, do not use the barbecue.
Inspect the burner for the correct flame pattern.
Clean, if necessary, according to the procedures
outlined in this section.
Check all gas fittings for leaks. See Step "Check for
gas leaks."
INSPECTING AND CLEANING THE BURNER
1. Turn OFF gas at the tank.
2. Remove the CharBin Storage Container.
3. Remove orifice clip and hose fitting from the
burner tube. Figure 12.
4. Look inside the burner with a flashlight.
5. Use the burner cleaning tool provided to clean
the air shutter area, the venturi section, and the
burner slots on the inside of the bowl. Be careful
when inserting the burner cleaning tool not to
damage the igniter electrode. Figure 13.
6. Recheck with flashlight to see that there are no
obstructions.
7. If necessary, surface of hose fitting can be cleaned
with a brass wire brush. The orifice can be cleaned
with a small pin. Figure 14.
CAUTION: Do not enlarge the orifice when
cleaning.
8. Reassemble by reversing steps 1 thru 3.
Venturi
Burner slot
Orifice
27
Orifice clip
Hose fitting
and orifice
Air shutter
Figure 12
Igniter electrode
Figure 13
Figure 14