Weber Performer Touch-N-Go Ignition Owner's Manual page 18

Note: Before sliding the CharBin into place check that
the Cooking grate holder is sitting loosely on the frame
brace and is conforming to the frame brace. Figure 14 a.
If it is tight or stuck over the edge of the frame brace,
Figure 14 b, reposition as in Figure 14 a.
If the Cooking grate holder is not correctly positioned, it
could allow the CharBin to slide through the frame.
Slide CharBin down into the top frame with the deep end
toward the rear. Figure 14.
Inside of
Frame Brace
Cooking grate
holder
(b)
Figure 14
(a)
CharBin
Step 13
Install ash catcher, control panel & bottom rack
You will need: ash catcher, control panel and bottom
rack.
Align handle and prongs of ash catcher with their
appropriate slots on the ash catcher ring. The handle fits
into the larger slot. Figure 15 (a).
Lift ash catcher up into slots and rotate to the right. Ash
catcher will fit securely into place. Figure 15 (b).
Set control panel in place over igniter and LP tank
handwheel. Figure 15.
Slide bottom rack into position between bottom
connectors. Figure 15.
(a)
Ash catcher handle
18
Control panel
(b)
Figure 15